Ítems similars: DESIGN, FABRICATION,AND FLIGHT TESTING OF GHOST WING "GW-1" MAV /
- DESIGN AND FABRICATION OF A FIXED-WING (UNMANNED AERIAL VEHICLE) TARGET DRONE FOR TESTING OF AIR DEFENSE SYSTEM /
- DESIGN AND FABRICATION OF A TARGET DRONE /
- LARGE DEFECTION ANALYSIS OF AN AIRCRAFT WING WITH ELLIPTICAL LIFT DISTRIBUTION AT DIFFERENT FLIGHT CONDITION /
- PASSIVE CONTROL OF WING ROCK IN A DELTA WING AIRCRAFT /
- DESIGN & FABRICATION OF WING CONTROLS,UNDERCARRIAGE AND SKIN OF HOME BUILT EXPERIMENTAL AIRCRAFT’’ MIST X-01’’ /
- STUDENT ANALYSIS OF AIRCRAFT WINGS WITH VARIOUS CONDITIONS /
Tema: Aeronautical Engineering.
- EXPERIMENTAL AND COMPUTATIONAL ANALYSIS OF DIFFERENT CHEVRON NOZZLES /
- STRESSES IN AN ANGLE PLY LAMINATED CANTILEVER UNDER TRANSVERSE LOADING /
- ADAPTIVE DRONE PATH OPTIMIZATION USING D*LITE, NONLINEAR MODEL PREDICTIVE CONTROL AND B-SPLINE TRAJECTORY PLANNING /
- DESIGN AND IMPLEMENTATION OF A COORDINATE UAV SWARM FOR LONG RANGE OPERATIONS /
- DESIGN AND FABRICATION ON VACUUM ASSISTED INFUSIUN MOLDING SETUP FOR FABRICATION OF FLAT AND CURVED COMPOSITE PANELS /
- SYNTHESIS AND CHARACTERIZATION OF JUTE-DERIVED CARBON MATERIALS FOR ADVANCED COMPOSITE AND WATER FILTRATION APPLICATIONS /
Tema: This Thesis Paper of AE in BSc Program.
- EXPERIMENTAL AND COMPUTATIONAL ANALYSIS OF DIFFERENT CHEVRON NOZZLES /
- ADAPTIVE DRONE PATH OPTIMIZATION USING D*LITE, NONLINEAR MODEL PREDICTIVE CONTROL AND B-SPLINE TRAJECTORY PLANNING /
- DESIGN AND IMPLEMENTATION OF A COORDINATE UAV SWARM FOR LONG RANGE OPERATIONS /
- DESIGN AND FABRICATION ON VACUUM ASSISTED INFUSIUN MOLDING SETUP FOR FABRICATION OF FLAT AND CURVED COMPOSITE PANELS /
- SYNTHESIS AND CHARACTERIZATION OF JUTE-DERIVED CARBON MATERIALS FOR ADVANCED COMPOSITE AND WATER FILTRATION APPLICATIONS /
- DESIGN AND COMPUTATIONAL ANALYSIS OF SUBSONIC LOITER MUNITION'S WING USING DIFFERENT AIRFOIL SECTION /